Guide Information Blogs

All Viper models are fitted with manually operated carburetor choke system. This choke is controlled by lever at the bottom of the left hand switch for control. When you first start the engine (cold), select lever to the full left position (or the choke closed) as the engine warms the return
lever in the full right position. (Choke open or off).To increase valve travel, thereby increasing the maximum speed, turn the throttle stop bolt run counter clockwise. To reduce the valve travel, thus reducing the maximum speed, turn the throttle stop bolt clockwise.

Use your front and rear brakes in combination to its speed when descending. Be careful not to apply too much pressure to your front brakes so that the wheels are locked, stop the shutdown and causing loss of steering. If the front wheels grates and stop turning slightly reduced pressure on the front brake lever until the unlock and start to turn.After every 100 hours of operation muffler must be cleaned by removing clean bolt using a wrench 12 mm. After every 60 hours of operation spark Arrester must be cleaned with the big retaining nut using a 10 mm socket. Use the pliers to turn the bag spark Arrester counterclockwise and pull out. here