Wednesday, July 25, 2012
Eton Viper 40E/RXL40E owner's manual
The Viper 40E model is equipped with safety connection key. It is situated on the left handle bar to switch to stop the engine. Cap key must be fully committed to the vehicle to run. The CAP is connected with a link that must be carried by the located on it. The engine of the vehicle can be stopped either by pulling the connection while becomes disconnected Cap key. This action will stop the engine.
Every time you load your unit, make sure the rubber seal inside the CAP for the cuts, tears and dirt. Clean or replace the seals, if it is found, worn or broken. The seal must be in good condition for the conclusion of proper print tank cap to prevent fuel spillage. Do not allow dirt or other debris on the introduction of the tank when refilling.It is important to check your tires and wheels for damage and wear before each session of riding. Inspect each tire for the cuts, tears and punctures. Inspect the rim for dents and separation of the wheel of rubber pellets get here
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.